iM5V Manual

Features

• • This product is made by 2.4G wireless transmitting technology with low consumption and strong ability to resist signal loss.
  • 5 kinds of output mode support 5 led strip (Single color/CCT/RGB/RGBW/RGB+CCT)
  • Support 2.4G remote control.
  • Built-in micro chip and support music rhythm

Parameters

1. Input 1
2. Input 2 (DC5521 Max 10A) 
3. Indicator
4. SET button
5. Output
6. Micro hole

Connection Diagram

For single color led strip (short press “SET”–white indicator)

For dual white led strip (short press “SET”– yellow indicator)

For RGB led strip (short press “SET”–red indicator)

For RGBW led strip (short press “SET”–green indicator)

For RGB+CCT led strip (short press “SET”–blue indicator)

Output mode settings

Short press (SET) continuously to select output mode, indicator displays different output modes as following diagram.

Setting PWM frequency

Long press “SET”until indicator flashes, short press “SET” continuously to select PWM frequency.

PWM frequency (changing different frequency to solve the noise problem from power adapter).

  High frequency only support device with lower wattage, low frequency support device with higher wattage and have better dimming performance. Factory default PWM frequency is 4KHz.

2.4G Remote Control

Linking code (2 different solution)

Solution 1

Short press “SET” 1 time, short press “ I ” 3 times within 3 seconds

Solution 2

Power off and power on, short press “ I ” 3 times within 3 seconds

  Link is done if the light flashes 3 times slowly

Cleaning Code (2 different solution)

Solution 1

Short press “SET” 1 time, short press “ I ” 5 times within 3 seconds

Solution 2

Power off and power on, short press “ I ” 5 times within 3 seconds

 Cleaning code is done if the light flashes 6 times quickly.

Dynamic Mode List (For remote control only)

Attention: brightness, saturation and speed are dimmable

Mini Brightness

1. Long press “  ” or “  ” in group zone 6 seconds until light flashes one time.
2. Short press “  ” or “  ” in group zone to set up 10 kinds of brightness level ( 1%, 5%, 10%, 15%, 20%, 25%, 30%, 35%, 40%, 50%).

  Short press any button except “OFF” to confirm or step out setting, the master “OFF”can set up all features.

ON/OFF Time

The light status changes gradually (factory default time is 0.5s).

1.5s: Short press “ON” 1 times and short press “OFF” 5 times within 3 seconds, the setting is done once light flashes 2 times slowly.

0.5s: Short press “OFF” 1 times and short press “ON” 5 times within 3 seconds, the setting is done once light flashes 2 times quickly.

Music Mode

Enter into music mode: Long press “M” button on remote until light flashes green color one time

Move out music mode: Long press “M” button on remote until light flashes red color two times

Warm Tips: 

1. Don’t block out the micro hole on controller.
2. Don’t install it into sealed junction box.

Attention

1. Please cut off power before wiring device
2. Please check the voltage of power adapter before connecting
3. Don’t disassemble it if you are not expert
4. Don’t use it in metallic or magnetic area